Skip to content
Nupdate
Source: ANS Nuclear Newswire

3D-printed tungsten tiles tested at DIII-D

A team from North Carolina State University, Oak Ridge National Laboratory, and JEOL has 3D-printed tungsten tiles for the inside wall of the DIII-D tokamak and tested them under plasma discharges with significant heat and particle flux. Manufacturing tungsten: In fusion machines where plasma-facing components are subjected to intense heat loads and irradiation, a material is needed that can survive these conditions and transfer the thermal energy away from the machine. Tungsten has been considered a leading material for the job. However, manufacturing tungsten into the required shapes can be…

Text analysis

Computed from the title and excerpt shown here, by fixed rules (no AI). Scores are only given for English text of enough length.

Tone
Neutral0 positive and 0 negative words
Reading level
Difficult

Long sentences or technical words. Expect to read it twice. Flesch score 36, about US grade 13.

Length
96 words, 5 sentences, 19.2 words per sentence
Word difficulty
35% long words (7+ letters), 5.6 letters on average

Reading aids

3D-printed tungsten tiles tested at DIII-D

A team from North Carolina State University, Oak Ridge National Laboratory, and JEOL has 3D-printed tungsten tiles for the inside wall of the DIII-D tokamak and tested them under plasma discharges with significant heat and particle flux. Manufacturing tungsten: In fusion machines where plasma-facing components are subjected to intense heat loads and irradiation, a material is needed that can survive these conditions and transfer the thermal energy away from the machine. Tungsten has been considered a leading material for the job. However, manufacturing tungsten into the required shapes can be…

How this was classified

Rule-based suggestions with their evidence. Anything marked low confidence is not confirmed.

  • Fusionrule match · 58% · keyword:"fusion" (excerpt) +1 more
  • General newslow confidence · 30% · default:no-signal-rule-matched

Nupdate shows a short feed excerpt only. Read the full publication at the original source (ANS Nuclear Newswire), published 5 Nov 2026.